Now loading.
Please wait.

Blog Entry

Rear Tailspring Assembly

posted in Construction, Video by

The tailspring must take substantial abuse from bad landings.  It is a stout assembly, reinforced with carbon fiber.

Start by sanding each of the 6mm tailboards.  You will laminate them together in the next step.

tailspring boards

tailspring boards gluing

After allowing the glue to set, remove the clamps and remove excess glue.  Sand until perfect.

If you are using a composite tailspring, drill and bolt together the assembly as shown in the following two photographs:

tailspring assembly

tailspring assembly 2

You will need to ensure that your rudder post is trimmed flush to the bottom fuselage line:

tailspring gluing preparation 2

Place the assembly into the correct flush position, and mark the location of the heads by pushing into the foam.

tailspring gluing preparation 4

tailspring gluing preparation 3

Using a flat bit, (or a sharp knife), open up the bolt head areas.  Then glue together using Gorilla glue.

tailspring gluing preparation 5

tailspring gluing preparation 6

To be continued….

02 Feb, 15

about author

 

 

related posts

 

 

latest comments

There are 0 comment. on "Rear Tailspring Assembly"

 

post comment